Elta 2444MP3 User Manual download pdf (Page 20)

SETTING UP AND CONNECTING

REPLACING Remote Control BATTERY

1. Turn over the remote control, and remove the battery door.

2. Install 1 “CR2025” lithium battery according to the polarity diagram on

the battery compartment.

3. Close the battery door.

BATTERY PRECAUTIONS

Follow these precautions when using battery in this device.

1. Use only the size and type of battery specified.

2. Be sure to follow the correct polarity when installing the battery as indicated in the battery

compartment. Reversed battery may cause damage to the device.

3. If the device is not to be used for a long period of time, remove the battery to prevent damage or

injury from possible battery leakage.

4. Do not try to recharge battery, not intended to recharge; they can overheat and rupture. (Follow

battery manufacturer's directions.)

Antenna

FM: Extend and move the FM Antenna Wire. If stereo broadcast

received, the STEREO indicator will be displayed on the

display (1). In case of Stereo stations with a bad reception

(noise infested reception), we recommend to pres MONO/ST

(25) button on remote control to MONO mode.

AM: This unit is equipped with a built-in directional ferrite antenna,

move and rotate the unit for best reception.

Speaker connection

To insert the speaker cables by pushing down the terminal lever of Left

Speaker Terminal (21) and Right Speaker Terminal (22).

Please ensure the cables are connected into the speaker terminals with

the correct polarities. Connect the left speaker to the terminals L and the

right speaker to the terminals R.

Headphones connection

Headphones Jack (16) is for headphones (not included) with 8-32 Ohm impedance (3.5mm jack). Use

corresponding adaptors (specialist shops) if you have different plugs. The speakers are automatically

switched off when the headphones are being used.

CAUTION: Listening at high power for a long moment could damage users' ears.

LINE IN (AUX IN) connection

1. Connect one end of a RCA plug signal wire (not included) to Aux Input Socket (18) and the other

end of wire to your home equipment. Make sure the polarity of the right and the left channel is

correct.

2. Press the POWER (4, 37) to switch on the unit

3. Press FUNC (36) repeatedly until display indicates “AUX”.

4. Play your home equipment.

 020.

Grey

2444MP3 DE,GB,FR &HR 9/7/05 3:29 PM Page 020

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 155 156

Comments to this Manuals

No comments

Elta 2444MP3 User Manual Page 20

Comments to this Manuals

Related products and manuals for CD players Elta 2444MP3